You are visiting the Canada Kee Safety website from United States. Would you like to go to the United States site?
As winter approaches, motorists scramble to change their windshield wipers for winter blades. With good reason. Snow and ice clog the exposed frames of regular blades, and their rubber composition hardens in the cold, causing streaking and poor visibility. Winter blades have a protective boot that covers the frame, and their softer rubber stays flexible in lower temperatures, maintaining better contact with the windshield.
The Canadian climate also affects industrial workplaces, as snow, ice, and freezing rain turn outdoor walkways, stairs, elevated platforms, rooftop equipment expanses, and loading zones into high-hazard areas. Winter workplace safety demands more than shoveling and salting.
Instead of the figurative equivalent of swapping out wiper blades, safety managers should install permanent infrastructure that protects workers year-round and then take extra precautions for winter.
Winter slip hazards develop wherever moisture, snow, and ice collect on walking surfaces. Freeze-thaw cycles make conditions unpredictable, as melting snow refreezes into thin, hard-to-see ice layers of ice and leaves black ice on metal grating. Industrial sites add further risks:
A temporary cone or caution sign is not enough when the hazard lasts for months. Effective slip, trip, and fall prevention must address both the walking surface and its surroundings.
Workplace safety in Canada is governed primarily by provincial and territorial Occupational Health and Safety (OH&S) legislation. Federally regulated employers fall under Part II of the Canada Labour Code and the Canada Occupational Health and Safety regulations (COH&S). Fall hazards are addressed in Part XII of those regulations, including sections 12.06 to 12.09.
Two principles run through most jurisdictions:
The most effective winter maintenance safety strategy is passive protection that works without relying on worker behavior. Permanent guardrails and access systems stay in place through routine operations and snowstorms. They should be constructed of anodized aluminum or hot-dip galvanized steel for strength, durability, and corrosion resistance.
Roof hatches, ladder access points, and skylights pose severe risks when snow and ice reduce visibility and traction. This is critical when technicians are carrying tools and wearing heavy gear.
When snow, ice, and debris accumulate on the rooftop during winter, workers face an extreme fall hazard. Raised, designated routes give workers predictable, safe paths with reliable footing.
A Canadian food processor installed anti-slip walkways and perimeter guardrails to provide workplace fall prevention. The walkway system with crossovers remained highly visible on an otherwise snow-covered roof. The non-penetrating industrial fall prevention systems kept the new roof warranty intact.
Large equipment housed on the rooftop, such as HVAC units and communications towers, needs year-round attention. Portable ladders and improvised scaffolding are non-starters, especially during the winter. When workers need to reach panels, instruments, and filters, work access platforms provide a stable, ergonomic walking-working surface for efficient inspections, maintenance, and repairs. They are built with aluminum or galvanized steel frames, anti-slip treads for steps and platform decks, and compliant guardrails. Modular designs let platforms fit the contours of the equipment being serviced.
Where guardrails are not practical, but fall protection is mandatory, an engineered tie-off system prevents workers from reaching the hazard (travel restraint) and arrests a fall safely.
Passive guardrails, anti-slip walkways, safe access platforms, and fall-arrest systems can keep workers protected between maintenance cycles during harsh winter weather and throughout the year. Before winter begins, inspect outdoor stairs, walkways, guardrail fittings, gate latches, platform structures, and lifeline/anchorage systems. Establish snow and ice removal procedures, apply suitable traction materials, and keep designated routes clear for optimal workplace safety in Canada.
How do We Assess a Risk on Your Rooftop?
Kee Safety Fall Protection Experts perform a critical analysis of the entire rooftop surface to identify the hazards where workers are exposed to the greatest risk. This ensures that the most dangerous areas are protected immediately with state-of-the-art fall protection systems and OH&S compliant solutions.